These devices are usually made with plastic, ceramic, thermoplastic paint, glass or occasionally metal, and come in a variety of shapes and colors. The blue marker denotes a fire hydrant on the left sidewalk.Ī raised pavement marker is a safety device used on roads. Traffic Supply, Inc stocks bituminous adhesive in 55lb boxes.The orange markers separate opposing traffic lanes. The hot bituminous liquid is applied to the pavement surface, a marker or delineator is set into the hot puddle, which subsequently cools and anchors the object to the paved surface. There's no epoxy mess and no time lost waiting for epoxy to cure when using Bundy pads.īituminous Rubber Adhesive requires a kettle to uniformly heat the bricks back to a liquid state. Installation is similar to using butyl rubber pads, except that the pad is heated until fully melted before applying the marker. Ten gallon epoxy sets are stocked for high volume uses, such as the placement of concrete car stops to surfaces that cannot be cored and pinned.ĥ" x 5" Black hot melt Bundy pads are available for the installation of raised pavement markers. Epoxy placed in a pile will generate more heat and set up quicker than if it was spread out over the mixing board. Equal portions of parts A & B are placed on a clean flat mixing surface (heavy cardboard, plywood or an old sign will work) and mixed until it's a uniform gray color. Although it's messy and has to be hand mixed, ounce for ounce, this is a less expensive way to purchase epoxy. Two gallon epoxy kits contain one gallon of resin and one gallon of hardener, enough material to set approximately 40 surface mounted delineators or 80-120 pavement markers. A standard twin barrel caulk gun is necessary to use this product. This eliminates hand mixing of the product and allows the product to be mixed and dispensed only as necessary. A disposable mixing tube (sold separately) is attached to the end of the cartridge. Cut open a corner of the pouch to dispense the product.Ħ00ml twin tube epoxy cartridges contain enough adhesive to place about 3 surface mount delineators or 7-10 pavement markers. To use this product, simply remove the sleeve and kneed the product in the pouch until it is a uniform gray color. The resin and hardener is packaged in a single pouch, separated by a plastic sleeve. Each kit contains enough adhesive to set 1 surface mounted delineator, or 1-2 raised pavement markers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |